PDA

View Full Version : 1D series bodies and lens performance


Harv
02-03-20073rd February 2007, 11:47 AM
Over time, I have seen many questions regarding 'IS' vs. "non-IS' lenses as well as teleconverter effect on AF. I recently read a white paper produced by Canon on 1D series cameras, and in this white paper they also addressed the issue of lens performance. The following are excerpts from that white paper:



Generally speaking, all USM lenses introduced since 1999, starting with the first 4
models in the IS (Image Stabilizer) super-telephoto series (300mm f/2.8L IS, 400mm
f/2.8L IS, 500mm f/4L IS and 600mm f/4L IS), autofocus noticeably faster than the
non-IS versions they replaced when used with an EOS-1 class digital SLR. Therefore, if
you want to experience the maximum performance of your EOS-1 class digital SLR in
terms of AF speed, you must use a recent lens.

The technical reason behind the improved performance lies in new programming on the
circuit board in the lens that supplies an initial burst of electrical power to the USM
motor that’s twice as high compared to the older lenses. The USM motor takes
advantage of this extra power to focus the lens faster.

All single focal length L-series lenses from 135mm to 1200mm plus several L-series
telephoto zooms are compatible with Canon’s 1.4x and 2x EF Extenders. These
accessories are understandably popular among professional and advanced amateur
photographers because of the extra value they offer in terms of increased focal length
without forcing the photographer to invest in longer prime lenses.

Of course, there are trade-offs for this convenience. The 1.4x and 2x Extenders cost 1 or 2
f/stops respectively. This means, for example, that a 300mm f/2.8 lens when used with a
2x extender becomes a 600mm f/5.6. Additionally, EF Extenders reduce lens drive speed.
As noted in the instruction sheets supplied with the Extenders, the EF 1.4x or 1.4x II
reduces lens drive speed by approximately 50~67% depending on the lens in use. The EF
2x or 2x II reduces lens drive speed by up to approximately 75%. This speed reduction
gives the AF system more time to detect focus. This is helpful since the depth of focus is
reduced with the longer effective focal length and the chance of defocus increases.
However, the reduced tracking speed and smaller maximum apertures (that sometimes
result in the loss of cross-type sensor focus detection as mentioned in the description of
the 45-point Area AF Sensor at the beginning of this document) caused by the use of
Extenders can be a disadvantage with fast moving subjects, particularly in low light.



If you have an interest in seeing the entire document, it can be found at:

http://www.photoworkshop.com/canon/EOS_Digital.pdf

There is a lot of other interesting information on how to get the most out of your 1D series camera.

pcho
02-03-20073rd February 2007, 04:06 PM
Thanks Harvey. Thats pretty interesting reading.

Perry

Mao
02-03-20073rd February 2007, 05:28 PM
Yup, when the 2X goes on my 500, it is absolutely useless for BIF. Another excuse to get something else. My $0.02 worth.

Harv
02-04-20074th February 2007, 05:01 AM
Thanks Harvey. Thats pretty interesting reading.

Perry

You're welcome, Perry. I found a few tidbits in there myself.

Yup, when the 2X goes on my 500, it is absolutely useless for BIF. Another excuse to get something else. My $0.02 worth.

Since when do you need an excuse? :biglaugh:

Jeff JTPhoto
02-04-20074th February 2007, 09:36 AM
Good info Harv..
No excuses Mao. Just get that 1200mm..